Where can I find communication software for DT-930?
Please, select Downloads / Tools / Patches in the navigation bar on the left pick the right software for your type of cradle. The package for LMWin also includes the driver software for HA-E60IO. You will find the driver "IRXpress" for USB in the installation directory of LMWin. The driver software must be installed separately after the installation of LMWin is finished.
How can I use CASIO Multidrop communication software to transfer files between PC and mobile device?
How must I configure LMWin on PC to use the HA-E60IO cradle?
On PC you can make several settings for LMWin. All settings are saved to the configuration file "device.ini". You can find the configuration file In the installation directory of LMWin on PC. Hence, you can also work with a pre-configured configuration file that must be copied to the installation directory. In this connection we would like to draw your attention to the entry for "IF", that must be set to "B.S/B.B", and the section [USE_DEVICE], that must have an entry for "CASIO:IRDA".
How must I configure the IRXpressUSB driver software for HA-E60IO?
Always use most recent version of the driver software that comes with LMWin 7.02 or later. For 64bit systems you need LMWin 7.08 or later. Verify that communication speed is adjusted to 4 MBps. You can check the settings in the device manager on your PC in the section for infrared devices. Please note, that the cradle must be connected to PC to make the settings appear in the device manager.
Please, check the points mentioned below:
Check the system requirements
Install LMWin 7.02 or later (7.08 or later required for 64bit) and required driver software
Always carry out the installation as administrator
It might be necessary to disable any software for virus protection during installation
Disable all other infrared devices in the device manager
Disable OBEX and/or "Wireless Link" via infrared in the control panel
Disable all other software applications that might access the infrared port, e.g. Microsoft ActiveSync
Verify the settings for IRXpressUSB (see above and DT-930 LMWin Method.pdf)
Adjust the settings in the device.ini file for LMWin (see above and DT-930 LMWin Method.pdf)
Set valid date and time on DT-930
Check the communication settings on DT-930 (Port = "FIR")
If it is still not working, please send us an email and report the serial number of the affected device